Just started to build my Aeronaut Diva kit. This is the first time building as I am a novice at building, I am following the book and it seems to be going well at the moment.

Update I have gone on to the next stage of my plan. I tried to take some pictures of the next build stage but there was something wrong with my camera. I will try and take a picture tomorrow.👍

Update: This is the next stage I have done according to the installation manual. I dried fitted it three times and mask taped up to make sure it fitted ok then I glued it together. I could not take photos yesterday as camera had a fault. The fitting seems to have gone pretty well any comments please let me know in case I have to rectify anything.

I have sealed my hull from leaks with Z-Poxy finishing resin PT40 also varnished the mahogany. I will take some photos at a later stage.

Robert👍

Glued side walls and top deck. All varnished. Sealed hull from leaks with Z-Poxy PT40. Next part of Instruction manual is installing motor and prop shaft. Job seems to have gone very well at the moment.

Update

Built up cabin, all varnished and accessories fitted, seems to fit ok. I will be sorting the deck out next then I will line the motor and propshaft in place to make sure it fits ok and fit the rudder and servo all seems to have gone well at the moment.