Hi All
I bought this boat as a unfinished project with an used radio and Merco 40 motor.
Sold the motor with the new electric starter and started pulling the boat apart.
Removed all the old driveline etc.
Repaired the forward deck and removed the paint.
Stripping down the cabin to repaint, also removing cockpit floor and seats.

Hi All
Started on fixing the bits I broke in removing the old paint.
The forward window had a gap in the middle to the deck, so I added timber behind the bottom of the window and filled in the gap.
Masking tape to the deck and combing, a lump of filler, sit the cabin down and wait for the filler to dry.
Remove cabin, masking tape, trim and sand down.
As the aft of the cabin sits over the deck a fair bit, I added a plywood piece back to the combing so to strengthen the aft cabin area and replaced the bottom section under one of the windows.
Remodelling this boat and building the SG&K 1920 Gentleman's Runabout is keeping me busy!!!
This retirement is great, but, I still liked my old job.
Canabus

I repaired one side and made a window for the forward window.
Canabus

Hi All
Started deck planking after finishing filling all the holes in the hull.
Canabus

Hi All
Started the easy deck planking!!

Canabus

Hi All
Just a few more planks !!!

Canabus

Hi All
The deck is all vanished and onto the cabin.

Canabus

Hi All
Painted the cabin white with blue sides and installing a little larger rudder.
Canabus

Hi All
Started on all the side, rear and front windows.
Installed all the running gear and radio.
The windscreen is going to be fun to make in two pieces!!!!
May drop it in the water tomorrow for a ballast test and a short run without the cabin.

Canabus